Peripheral Camera System, Calibrating

-- The vehicle must be on a level surface.

NOTE:

The vehicle in the illustration is only a basic outline.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Roll out the Calibration System at the left and right near the vehicle.

-- Install the rear and front clamping strip on the :VAS721001  .

-- Align the crosshairs -2- to the front axle of the vehicle (center front wheel).

-- Align both calibration devices parallel. The vehicle must be located in the center between both calibration devices.

Pay attention to the following measurement requirements:

• Dimension -a- 2000 to 2500 mm ± 2 mm (78.74 to 98.4 ± 0.07 in.), front and rear the same
• The dimension -b- must be the same on both sides
• The dimension -c- must be the same on both sides

-- Set-up the requirement for the vehicle. Refer to REQUIREMENT FOR THE CALIBRATION OF THE VEHICLE .

-- Connect the Vehicle Diagnostic Tester.

Calibrating Procedure 

-- Select the Diagnostic  mode and start the diagnosis.

-- Select the Test plan  tab.

-- Press the Select individual test  button and select the following one after the other:

• Body
• Electrical Equipment
• 01  - OBD-capable systems
• 6C  - Peripheral camera control module | J928
• 6C  - Peripheral camera control module, functions
• 6C  - Calibration

From here, the Vehicle Diagnostic Tester advances the calibration procedure forward.