| 1 |
- PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK
-- Was Complaint Verified? |
-- YES:
-- NO:
- Gather more Information from customer about the complaint
|
| 2 |
- DISCONNECT: Particulate Sensor -G784- harness connector
- IGNITION: ON
- CHECK: Particulate Sensor -G784- harness connector terminals 1 to 4 for voltage.
- SPECIFIED VALUE: About Battery voltage.
- IGNITION: OFF
-- Was value obtained? |
-- YES:
-- NO:
- CHECK: wiring for open, high resistance, short or electrical connector for damage, corrosion, loose or broken terminals
- REPAIR: faulty wiring.
- GO TO: Step 4
|
| 3 |
- REMOVE: Engine Control Module - J623-. Refer to appropriate service information.
- CHECK: Particulate Sensor -G784- harness connector terminal 2 to the Engine Control Module - J623- harness connector T91 / 52 for resistance.
- CHECK: Particulate Sensor -G784- harness connector terminal 3 to the Engine Control Module - J623- harness connector T91 / 51 for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω)
-- Was value obtained? |
-- YES:
- REPLACE: Particulate Sensor -G784-. Refer to appropriate repair information.
- GO TO: Step 4
-- NO:
- CHECK: wiring for open, high resistance, short or electrical connector for damage, corrosion, loose or broken terminals
- REPAIR: faulty wiring.
- GO TO: Step 4
|
| 4 |
- Final Procedure
- Perform a road test to verify repair.
- Do any DTC's return:
|
-- YES:
-- NO:
- Repair is complete, Generate readiness code. Refer to READINESS CODE
.
- Return vehicle to Customer
|