Selector Lever Cable, Adjusting
Special tools and workshop equipment required
- Socket and KeyT40031
Procedure
- Tightening specification. Refer to SELECTOR LEVER CABLE .
-- Unclip the frame for the selector lever boot -1- and remove it from the center console -arrows-.
-- Move the selector lever into "S".
The clamping screw is only accessible when the selector lever is in "S".
Loosen locking screw approximately 1 turn - do not remove completely
-- Loosen the clamping screw on the selector lever cable approximately one turn using the Socket and KeyT40031.
-- Carefully move the selector lever forwards and backwards slightly without shifting to a different selector lever position.
This loosens the selector lever cable.
-- Turn on the ignition.
The Two Following Conditions Must be Fulfilled
- "S1" must appear in the Transmission Range Display -Y6-.
- The "S" inside the Selector Lever Transmission Range Position Display Unit -Y26- must be illuminated.
Conditions Are Not Fulfilled
-- Tighten the clamping screw -arrow- for the selector lever cable in this position using the Socket And KeyT40031.
-- Check the DTC memory in OBD . Refer to Vehicle Diagnostic Tester.
-- Check in Guided Fault Finding . Refer to Vehicle Diagnostic Tester.
-- Check the adjustment on the Multifunction Transmission Range Switch -F125-. Refer to Multifunction Transmission Range Switch -F125-, REMOVING, INSTALLING AND ADJUSTING .
-- Adjust the selector lever cable again. Refer to SELECTOR LEVER CABLE, ADJUSTING .
Conditions Are Fulfilled
Do not move the selector lever forward or backward while tightening the clamping screw otherwise the adjustment will be incorrect.
-- Tighten the bolt -arrow- on the selector lever cable using the Socket And KeyT40031.
Install in reverse order of removal.
-- Check the selector mechanism. Refer to GEARSHIFT MECHANISM, CHECKING .