| 1 |
- PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK
-- Was complaint verified? |
-- YES:
-- NO:
- Gather more Information from customer about the complaint
|
| 2 |
- IGNITION: OFF
- DISCONNECT: Faulty Fuel Injector -- harness connector.
- CHECK: The faulty Fuel Injector -- terminals for resistance. (*Refer to the wiring diagram for proper terminal locations*).
- SPECIFIED VALUE: 5 - 8 Ω (@ approx. 20°C)
-- Was value obtained? |
-- YES:
-- NO:
- CHECK: wiring for opens, high resistance, short or electrical connector for damage, corrosion, loose or broken terminals
- REPAIR: faulty wiring or connector
- GO TO: Step 4
|
| 3 |
- REMOVE: Engine Control Module - J623-. Refer to appropriate service information.
- CHECK: Faulty Fuel Injector -- harness connector terminals to the Engine Control Module - J623- harness connector terminals. (*Refer to the wiring diagram for proper terminal locations*) for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω)
-- Was value obtained? |
-- YES:
- REPLACE: Engine Control Module -J623- Refer to appropriate repair information
- GO TO: Step 4
-- NO:
- CHECK: wiring for open, high resistance, short or electrical connector for damage, corrosion, loose or broken terminals
- REPAIR: faulty wiring or connector
- GO TO: Step 4
|
| 4 |
- Final Procedure
- Perform a road test to verify repair.
- Do any DTC's return:
|
-- YES:
-- NO:
- Repair is complete, Generate readiness code. Refer to READINESS CODE
.
- Return vehicle to Customer
|