Filling ATF

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi A6 Quattro, 2015 Audi A6, 2014 Audi A6 Quattro, 2014 Audi A6, and 2013 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rotating Shut-Off Valve In Direction Of Filler Hose & Filling ATF Into Transmission

Courtesy of AUDI OF AMERICA, LLC

Engine continues running at idle.

-- Turn the valve to the filler hose -lower arrow-. The ATF flows into the transmission.

-- Turn the valve in the flow direction -down arrow- and check the ATF level.

Fig 2: Checking ATF Level By Rotating Shut-Off Valve In Direction Of Outlet

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Approximately 5 to 10 cl of ATF will initially drain from the internal oil level pipe. This is normal.

-- If no ATF leaks out, then turn the valve back toward the filler hose and let more ATF flow in. Check the ATF level again.

At 35 °C (95 °F) the ATF must flow out steadily and at first strongly, if necessary repeat the filling procedure.

-- Wait until just a little ATF is coming out.

-- After reaching the correct ATF level, remove the CVT Gearbox Filler System VAS 5162 connection again.

NOTE:

After removing the connection, the ATF will flow again.

-- Tighten the new ATF check plug -A-.

Fig 3: ATF Inspection Plug

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Depending on the version, ATF inspection plugs of different lengths are installed. Always pay attention to the allocation according to the transmission codes . To prevent damaging the transmission, compare the old and new ATF inspection plug.

NOTE:

The ATF check plug must be installed again before the ATF reaches a temperature of 45 °C (113 °F) or 50 °C (122 °F) with hot climates.

If the ATF gets warmer than 45 °C (113 °F), it will leak out and the transmission will not have enough ATF.

Tightening Specifications

Refer to -item 1- in OVERVIEW - ATF CIRCUIT
Refer to REAR NOISE INSULATION, REMOVING AND INSTALLING .