Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Audi >> 2013 >> S7 >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Controls, Housing - Continuously Variable Transmission) >> 37 Controls, Housing >> ATF Circuit >> ATF Pipes, Removing And Installing >> Installing >> Notes

ATF Pipes, Removing And Installing: Installing: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi A6 Quattro, 2015 Audi A6, 2014 Audi A6 Quattro, 2014 Audi A6, and 2013 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the o-rings.

-- Coat the o-ring with ATF before installing.

-- Insert the ATF lines with the new O-ring by hand until they stop.

CAUTION:

Danger of causing damage to the transmission.

  • Remove all the plugs on the ATF pipes and on the transmission that were installed during removal.
  • The ATF cooling function will not work and the transmission will be damaged if the plugs are forgotten.

-- Check the ATF level and correct if necessary, refer to ATF LEVEL, CHECKING .

scientia non olet · About Mike's Workshop Manuals