Data Bus On Board Diagnostic Interface -J533-: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S6, 2015 Audi A6 Quattro, 2015 Audi A6, 2014 Audi S6, and 2014 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

For the correct tightening specification. Refer to Data Bus On Board Diagnostic Interface -J533- OVERVIEW and refer to appropriate SYSTEM WIRING DIAGRAMS information..

Install in reverse order of removal. Note the following:

If the Data Bus on board diagnostic interface was replaced, then the new one must coded again using the Vehicle Diagnostic Tester in Guided Fault Finding.

-- Install the rear seat bench. Refer to REAR BENCH SEAT .