Brake Lamp Switch -F-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S6, 2015 Audi A6 Quattro, 2015 Audi A6, 2014 Audi S6, and 2014 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The plunger adjusts itself automatically while the Brake Lamp Switch -F- is being installed.

The brake pedal must remain in end position during installation and must not be moved.

The brake pedal must be connected with the brake booster.

The brake pedal is in the resting position. Do not press the brake pedal.

-- Install the Brake Lamp Switch -F- into the mount -C- on the brake pedal and press on it -arrow A- lightly.

Fig 1: Identifying Brake Lamp Switch And Mount

Courtesy of AUDI OF AMERICA, LLC

NOTE:

All three tabs on the Brake Lamp Switch -F- must audibly engage.

Do not turn the Brake Lamp Switch -F- once it is inside the mount on the brake pedal.

The plunger adjusts itself automatically while the Brake Lamp Switch -F- is being installed.

-- Turn the color piece on the Brake Lamp Switch -F- all the way to the right -arrow B- to the lock the Brake Lamp Switch -F-.

Fig 2: Identifying Brake Lamp Switch And Mount

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector.

-- Install the footwell vent.

-- Install the storage compartment under the instrument panel on the driver side. Refer to STORAGE COMPARTMENTS AND COVERS .

CAUTION: Make sure the Brake Lamp Switch -F- is working correctly before driving the vehicle for the first time.