Rearview Camera System Control Module -J772-, REMOVING AND INSTALLING: Removing

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Remove the right luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL (Sedan) or LUGGAGE COMPARTMENT SIDE TRIM PANEL (Wagon) .

The bracket must be removed first in order to be able to remove the Rearview Camera System Control Module -J772-. It is attached with screws to the relay and fuse panel F inside the luggage compartment on the right side. The relay and fuse panel F in the luggage compartment on the right side must first be removed. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL (Sedan) or LUGGAGE COMPARTMENT SIDE TRIM PANEL (Wagon) .

Removing the bracket

-- Unlock and disconnect all of the connectors from the control modules.

-- Remove the nuts -arrows- and remove the bracket -1- along with the control modules from the luggage compartment recess.

Fig 1: Removing Nuts -Arrows- And Remove Bracket -1-

Courtesy of AUDI OF AMERICA, LLC

The Rearview Camera System Control Module -J772- -1- is only clipped into the bracket -2-.

Fig 2: Disconnecting Connectors From Rearview Camera System Control Module -J772- -1-

Courtesy of AUDI OF AMERICA, LLC

-- Release and disconnect the connectors from the Rearview Camera System Control Module -J772- -1-.

-- Press the retainer downward and remove the Rearview Camera System Control Module -J772- -1- from the bracket -2-.