Service Interval Display, Resetting With ODIS
Warning information for the high voltage system:
Procedures for which the ignition needs to be switched on. Refer to PROCEDURES FOR WHICH THE IGNITION NEEDS TO BE SWITCHED ON .
Reference the maintenance table to see which service channel was reset and which intervals were stored.
-- Connect the Vehicle diagnostic tester. Refer to Vehicle Diagnostic Tester, CONNECTING .
-- Select Diagnosis operating mode and start diagnosis.
-- Select the VIN.
-- Remove V and press Accept to deselect "Work with guided fault finding".
-- Continue following the program procedure.
-- Select Special functions tab.
-- Select the service you want to reset. For example, "17 - Inspection" and start with Perform test... .
-- Continue following the program procedure.