Overview - Ignition System
WARNING: This page is about a different variant/trim than selected.
- Knock Sensor
- Cylinder bank 1 (right) Knock Sensor 1 -G61- and Knock Sensor 2 -G66-
- Cylinder bank 2 (left) Knock Sensor 3 -G198- and Knock Sensor 4 -G199-
- Removing and installing, refer to KNOCK SENSOR, REMOVING AND INSTALLING
- Bolt
- 20 Nm
- O-Ring
- Replace
- Camshaft Position Sensor
- Intake side Camshaft Position Sensor -G40-
- Exhaust side Camshaft Position Sensor 2 -G163-
- Removing and installing, refer to CAMSHAFT POSITION SENSOR, REMOVING AND INSTALLING
- Bolt
- 9 Nm
- Spark Plug
- Replacement interval, refer to MAINTENANCE INTERVALS
- Tightening specification, refer to SPARK PLUGS, REPLACING
- Ignition Coil
- Removing and installing, refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING
- Connector
- Bolt
- 5 Nm
- Bolt
- 9 Nm
- Camshaft Position Sensor
- Intake side Camshaft Position Sensor 3 -G300-
- Exhaust side Camshaft Position Sensor 4 -G301-
- Removing and installing, refer to CAMSHAFT POSITION SENSOR, REMOVING AND INSTALLING
- O-Ring
- Replace
- Engine Speed Sensor -G28-
- Removing and installing, refer to ENGINE SPEED SENSOR -G28-, REMOVING AND INSTALLING
- Bolt
- 4 Nm + an additional 45° turn
- Replace