Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Audi >> 2012 >> A6 2.0T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Controls, Housing - Automatic Transmission) >> 37 Controls, Housing >> Selector Mechanism >> Selector Mechanism, Removing And Installing >> Installing

Selector Mechanism, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

-- Install the selector mechanism function unit and tighten it from the top.

-- Install selector lever cable. Refer to Installing .

-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- Check the selector mechanism. Refer to GEARSHIFT MECHANISM, CHECKING .

-- Install the driveshaft intermediate bearing. Refer to REAR FINAL DRIVE 0BC, 0BD, 0BE & 0BF .

-- Install the front ashtray or storage compartment. Refer to FRONT ASHTRAY/STORAGE COMPARTMENT or STORAGE COMPARTMENT .

-- Install the selector lever handle. Refer to Installing .

scientia non olet · About Mike's Workshop Manuals