| 1 |
- PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK
.
-- Was Complaint verified? |
-- YES:
-- NO:
- GATHER more information from customer about the complaint.
|
| 2 |
- IGNITION: OFF.
- DISCONNECT: Suspect Fuel Injector -- from harness connector.
- CHECK: Suspect Fuel Injector -- component connector terminals 1 to 2 for resistance (refer to the wiring diagram for proper terminal locations).
- SPECIFIED VALUE: 0.5 - 15 Ω (@ approx. 20° C).
-- Was Value obtained? |
-- YES:
-- NO:
|
| 3 |
- REMOVE: Engine Control Module - J623-. Refer to appropriate service information.
- CHECK: Suspect Fuel Injector -- harness connector terminal 1 to the Engine Control Module - J623- harness connector terminal (refer to the wiring diagram for proper terminal locations) for resistance.
- CHECK: Suspect Fuel Injector -- harness connector terminal 2 to the Engine Control Module - J623- harness connector terminal (refer to the wiring diagram for proper terminal locations) for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Were Values obtained? |
-- YES:
-- NO:
- PERFORM: Visual Inspection of wiring and component.
- CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
- REPAIR: Faulty wiring or connector.
- GO TO: Step 4 FUEL INJECTORS, CHECKING - 4 .
|
| 4 |
Refer To The Final Procedure Below; |