| 1 |
- PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK
.
-- Was Complaint verified? |
-- YES:
-- NO:
- GATHER more information from customer about the complaint.
|
| 2 |
- IGNITION: OFF.
- DISCONNECT: Engine Coolant Temperature Sensor -G62- harness connector.
- CHECK: Engine Coolant Temperature Sensor -G62- component connector terminals 1 to 2 for resistance.
- SPECIFIED VALUE: 2, 250 Ω (+/- 750 @ approx. 20° C).
-- Was Value obtained? |
-- YES:
-- NO:
|
| 3 |
- REMOVE: Engine Control Module - J623-. Refer to appropriate service information.
- CHECK: Engine Coolant Temperature Sensor -G62- harness connector terminal 1 to the Engine Control Module - J623- harness connector T60 / 14 for resistance.
- CHECK: Engine Coolant Temperature Sensor -G62- harness connector terminal 2 to the Engine Control Module - J623- harness connector T60 / 57 for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Were Values obtained? |
-- YES:
-- NO:
- PERFORM: Visual Inspection of wiring and component.
- CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
- REPAIR: Faulty wiring or connector.
- GO TO: Step 4 Engine Coolant Temperature Sensor -G62-, CHECKING - 4 .
|
| 4 |
Refer To The Final Procedure Below; |