| 1 |
- PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK
.
-- Was Complaint verified? |
-- YES:
-- NO:
- GATHER more information from customer about the complaint.
|
| 2 |
- CONNECT: Scan Tool.
- IGNITION: ON.
- CHECK: Throttle valve position closed:
- SPECIFIED VALUE: 3 - 25%.
- DEPRESS: Accelerator pedal slowly to WOT while observing the percentage display. The percentage display must increase uniformly.
- CHECK: Throttle valve position at WOT:
- SPECIFIED VALUE: 84 - 99%.
- IGNITION: OFF.
-- Was Value obtained? |
-- YES:
- Condition may be intermittent.
- PERFORM: Visual Inspection of wiring and component.
- CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
- REPAIR: Faulty wiring or connector.
- GO TO: Step 6 Accelerator Pedal Module - GX2-, CHECKING - 6 .
-- NO:
|
| 3 |
- DISCONNECT: Accelerator Pedal Module - GX2- harness connector.
- IGNITION: ON.
- CHECK: Accelerator Pedal Module - GX2- harness connector terminals 2 to 3 and 1 to 5 for voltage.
- SPECIFIED VALUE: About 5.0 V.
- IGNITION: OFF.
-- Were Values obtained? |
-- YES:
-- NO:
|
| 4 |
- REMOVE: Engine Control Module - J623-. Refer to appropriate service information.
- CHECK: Accelerator Pedal Module - GX2- harness connector terminal 4 to the Engine Control Module - J623- harness connector T94 / 83 for resistance.
- CHECK: Accelerator Pedal Module - GX2- harness connector terminal 6 to the Engine Control Module - J623- harness connector T94 / 61 for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Were Values obtained? |
-- YES:
-- NO:
- PERFORM: Visual Inspection of wiring and component.
- CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
- REPAIR: Faulty wiring or connector.
- GO TO: Step 6 Accelerator Pedal Module - GX2-, CHECKING - 6 .
|
| 5 |
- REMOVE: Engine Control Module - J623-. Refer to appropriate service information.
- CHECK: Accelerator Pedal Module - GX2- harness connector terminal 2 to the Engine Control Module - J623- harness connector T94 / 82 for resistance.
- CHECK: Accelerator Pedal Module - GX2- harness connector terminal 3 to the Engine Control Module - J623- harness connector T94 / 35 for resistance.
- CHECK: Accelerator Pedal Module - GX2- harness connector terminal 1 to the Engine Control Module - J623- harness connector T94 / 81 for resistance.
- CHECK: Accelerator Pedal Module - GX2- harness connector terminal 5 to the Engine Control Module - J623- harness connector T94 / 11 for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Were Values obtained? |
-- YES:
-- NO:
- PERFORM: Visual Inspection of wiring and component.
- CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
- REPAIR: Faulty wiring or connector.
- GO TO: Step 6 Accelerator Pedal Module - GX2-, CHECKING - 6 .
|
| 6 |
Refer To The Final Procedure Below; |