Engine Speed (Rpm) Sensor -G28-
Special tools and workshop equipment required
- Socket Wrench 4 mm T10370
- Assembly Tool T10118
Removing
-- Remove the noise insulation -1-. Refer to Removal and Installation .
-- Remove the oil filter bracket. Refer to [For engine(s) CBEA] Description and Operation .
-- Disconnect the connector on the RPM) sensor -arrow- using T10118.
NOTE:
To release the connector without the T10118, push the connector against the RPM sensor and simultaneously lift up on the release tab with a thin wire hook.
-- Remove the bolt -2- for the RPM sensor -1- using a T10370.
Installing
Install in reverse order, paying attention to the following:
-- Install the oil filter bracket. Refer to [For engine(s) CBEA] Description and Operation .
- Tightening specifications, refer to COMPONENT LOCATION OVERVIEW