Shift Forks

Special tools and workshop equipment required 

• Pressure Plate VW 402
• Punch VW 411
• Sleeve VW 426
• Thrust Piece VW 431
• -1- Internal Puller 18.5 to 23.5 mm Kukko 21/3
• -4- Counter-Support Kukko 22/1

Fig 1: Identifying Selector Rods & Shift Forks

Courtesy of AUDI OF AMERICA, LLC

1. Rubber damper
   • Pull out and insert into selector rod by hand
2. Selector rod with shift fork for 1st and 2nd gear
3. Selector rod with shift fork for 3rd and 4th gear
4. Selector rod with shift fork for 5th and 6th gear
5. Reverse gear shift fork
   • From transmission manufacture date 06 03 6, ball sleeve  List Item:Ball sleeve has been omitted
   • Sliding omission
   • Reverse gear shift fork is adapted
   • Reverse gear shift fork differentiation, refer to Fig 2
6. Ball sleeve
   • Pulling out, refer to Fig 3
   • Installing, refer to Fig 4
   • From transmission manufacture date 06 03 6, ball sleeve has been omitted
   • Sliding omission

Fig 2: Identifying Reverse Gear Shift Fork Differentiation

Courtesy of AUDI OF AMERICA, LLC

Fig 3: Identifying Internal Puller & Support

Courtesy of AUDI OF AMERICA, LLC

A - Internal Puller 18 to 23 mm, for example Kukko 21/3

B - Support, for example Kukko 22/1

Fig 4: Identifying Tool Assembly To Press-In Reverse Gear Selector Fork Ball Sleeve

Courtesy of AUDI OF AMERICA, LLC