Mode 2: Checking operating conditions: Procedure
- Connect diagnostic tester. See DIAGNOSTIC TESTER, CONNECTING .
- In diagnostic function "33 - OBD", select "Mode 2: Check operating conditions."
- Select the desired operating condition via the DISPLAY OPERATING CONDITIONS: MODE 2 table according to the PID (Parameter Identification), e.g. "PID 05: Coolant temperature".
NOTE:
- Bank 1 = cylinder bank 1 in direction of travel, right; Bank 2 = cylinder bank 2 in direction of travel, left.
- Measuring values of Engine Control Module (ECM) are displayed under "10 - Engine electronics" and measuring values of Transmission Control Module (TCM) are displayed under "1A - Transmission electronics".
DISPLAY OPERATING CONDITIONS: MODE 2
| PID(1) | Display operating conditions | ||
|---|---|---|---|
| 02: | DTC which triggered the current reception of all control module information | ||
| 03: | Condition of the fuel system | ||
| 04: | Calculated load condition value | ||
| 05: | Coolant temperature | ||
| 06: | Short term fuel trim - Bank 1 | ||
| 07: | Fuel trim - Bank 1 | ||
| 08: | Short term fuel trim - Bank 2 | ||
| 09: | Fuel trim - Bank 1 | ||
| 12: | Engine rotations per minute (RPM) | ||
| 13: | Vehicle speed | ||
|
|||
If DTCs are displayed in "PID 02":
- Repair stored malfunction(s) according to DTC table:
- SAE P0xxx-DTCs, see DIAGNOSTIC TROUBLE CODE (DTC) TABLES:
- SAE P1xxx-DTCs, see SAE P1XXX-DTCS
- SAE P2xxx-DTCs, see SAE P2XXX-DTCS
- SAE P3xxx-DTCs, see SAE P3XXX-DTCS