ABS front axle components, removing and installing: Notes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following list refers to items in Fig 1.
- Hex bolt
- Always replace
- Different versions, see part catalog
Vehicle must not be raised when tightening this bolt.
Tightening torque:
- Clamping sleeve
- Always replace
- Left and right sides are identical
- Before installing, grease the hole in the wheel bearing housing with lubricating paste G 000 650
- Push into wheel bearing housing up to stop
- Sealing collar
- ABS wheel speed sensor
- Install drive axle before installing speed sensor.
- Push into clamping sleeve up to stop.
- Replacing, see ABS WHEEL SPEED SENSOR, REMOVING AND INSTALLING
- Drive axle with rotor
- Inspect rotor for signs of dirt and damage. See ROTOR, CHECKING .
- Replace outer CV joint if the rotor is damaged.
- Outer CV joint is supplied as replacement part with rotor.