Telephone/Telematic Control Module -J526-, replacing and reconfiguring: Replacing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Where applicable, carefully record the 8 character Station Identification (STID) number and Electronic Serial Number (ESN) from labels on replacement module.
Remove and replace control module and emergency (back-up) battery. See TELEPHONE/TELEMATIC CONTROL MODULE -J526-, REMOVING AND INSTALLING .
Switch on ignition, connect VAG 1551/1552 Scan Tool (ST) and enter address word 75 - "Telematics" ("Emergency call module" may appear on display).
Perform scan tool function 07 - Code Control Module, and enter applicable vehicle/equipment code. See CODE CONTROL MODULE (FUNCTION 07) .
Perform scan tool function 10 - Adaptation, and deactivate "Transport Mode" by entering/storing value "0" in adaptation channel 03. If necessary, refer to detailed procedure. See TRANSPORT MODE, ACTIVATING/DEACTIVATING .
Reset emergency battery time register by entering/storing value "1" in adaptation channel 08. If necessary, refer to detailed procedure. See EMERGENCY (BACK-UP) BATTERY, SWITCH ON/OFF, RESET TIME REGISTER .
Erase DTC memory (scan tool function 05). See DIAGNOSTIC TROUBLE CODE (DTC) MEMORY, ERASING (FUNCTION 05) .