Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Audi >> 1995 >> 90 Base, 2.8 A, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Controls - System/Component Tests) >> Fuel System >> Fuel Pressure Release

Fuel Pressure Release

WARNING: This page is about a different car, the 1995 Audi Cabriolet. However, it is still accessible from the selected car via links, so may be relevant.

Remove fuel pump relay. See ELECTRICAL COMPONENT LOCATIONS  . Start engine. Allow engine to run until it stops. Turn ignition off. Disconnect negative battery cable. Slight pressure may remain in system. Before disconnecting any fuel system line, cover connector with a clean shop towel. Install fuel pump relay.

scientia non olet · About Mike's Workshop Manuals