Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Audi >> 1980 >> 5000 Base, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> BOSCH Cis Injection System - AUDI & VOLKSWAGEN >> Removal & Installation >> Control Pressure Regulator For Warm Running Compensation

Control Pressure Regulator For Warm Running Compensation

CAUTION: On all models, disconnect battery ground cable and relieve fuel pressure before removing control pressure regulator.
  1. Clean fuel lines and disconnect. Remove electrical connections to regulator.
  2. Remove two screws holding regulator to engine block. Remove regulator and gasket.
  3. To install, reverse removal procedure, using new gasket.
scientia non olet · About Mike's Workshop Manuals