Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Alfa Romeo >> 2021 >> Stelvio Ti >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Drivetrain Control (DTCM) >> Removal And Installation >> Removal

Removal And Installation: Removal

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, use a diagnostic scan tool to perform the Flash Programming Procedure (if available). This will confirm that the module is updated to the latest applicable software level.

  1. Remove the belly pan. Refer to BELLY PAN, ENGINE, REMOVAL AND INSTALLATION or BELLY PAN, REAR, REMOVAL AND INSTALLATION or BELLY PAN, SIDE, REMOVAL AND INSTALLATION .
    GC0193509Courtesy of CHRYSLER GROUP, LLC
  2. Disconnect the Drivetrain Control Module (DTCM) wire harness connector (1).
    GC0195454Courtesy of CHRYSLER GROUP, LLC
  3. Remove the DTCM bolts (1a) and remove the DTCM (1b).
scientia non olet · About Mike's Workshop Manuals