Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Alfa Romeo >> 2021 >> Stelvio Ti >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Body Control (BCM) >> Removal And Installation >> Removal

Removal And Installation: Removal

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, use a diagnostic scan tool to perform the Flash Programming Procedure (if available). This will confirm that the module is updated to the latest applicable software level.

NOTE:

After performing a flash programming procedure on a BCM, the vehicle must be driven above 20kp/h (13 mph) to make sure all vehicle functions will operate normally.

  1. Disconnect and isolate the negative battery cable.
    GC0195171Courtesy of CHRYSLER GROUP, LLC
  2. Remove the fasteners (1a) securing the BCM access cover.
  3. Remove the access cover (1b) by releasing it from the lower side.
    GC0194171Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the Body Computer Module (BCM) (1h) electrical connections (1a, 1b, 1c, 1d, 1e, 1f, 1g).
  5. Remove the nuts (2a) securing the BCM.
  6. Remove the BCM (1h).
    GC0193354Courtesy of CHRYSLER GROUP, LLC
  7. If necessary, remove the screws (1a) to separate the BCM from the BCM support bracket (1b).
scientia non olet · About Mike's Workshop Manuals