Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Alfa Romeo >> 2021 >> Stelvio Ti >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Adaptive Front Lighting System (AFLS) >> Removal And Installation >> Removal

Removal And Installation: Removal

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, use a diagnostic scan tool to perform the Flash Programming Procedure (if available). This will confirm that the module is updated to the latest applicable software level.

  1. Disconnect and isolate the negative battery cable(s). Refer to STANDARD PROCEDURE .
  2. Remove the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL AND INSTALLATION .
    GC0194354Courtesy of CHRYSLER GROUP, LLC
  3. Working under the right side of the instrument panel, release the wire harness retainer (1a) from the fan unit.
  4. Working on the right side, remove the fasteners (2a) and move the AFLM (2b) to gain access to the wire harness electrical connector.
  5. Disconnect the wire harness connector (3a) from the AFLM.
scientia non olet · About Mike's Workshop Manuals