Removal And Installation: Installation
- Inspect the AFLM and wire harness connector integrity.
- Connect the wire harness electrical connector (1a) to the AFLM.
- Position the AFLM (1b) for installation, then install and securely tighten the fasteners (2a).
- Secure the wire harness to the wire harness retainer (3a).
- Install the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL AND INSTALLATION .
- Connect the negative battery cable(s). Refer to STANDARD PROCEDURE
.NOTE:
If this Electronic Control Unit (ECU) is being replaced with a new unit, use a diagnostic scan tool to perform the Flash Programming Procedure (if available). This will confirm that the module is updated to the latest applicable software level.
- When the AFLS module is replaced, the diagnostic scan tool needs to be used to calibrate the AFLS. Using the scan tool, select the AFLS and then select the "Misc Functions" menu. Select and start the "AFLS Calibration" routine. Follow the on-screen instruction to complete this procedure.
NOTE:
If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.