Switch - Passenger Front

Courtesy of CHRYSLER GROUP, LLC

REMOVAL

1. Disconnect and isolate the negative battery cable.
2. Using a trim stick or suitable tool, release the cover and remove the screw (1a).
3. Using a trim stick or suitable tool, lift the switch unit (2a) a little, disengaging the flexible retainers (2b) on both sides.
4. Disconnect the wire harness connector (3a).
5. Remove the power window switch (1a) from the vehicle.

Courtesy of CHRYSLER GROUP, LLC

INSTALLATION

1. Connect the wire harness connector (1a) of the switch (1b).
2. Position the switch unit (1b) in place and secure the retainers (2a).
3. Tighten the screw (3a) and install the cover.
4. Connect the negative battery cable.