DTC Troubleshooting: P0615(3.0L Engine): Inspection

START_DIAG [ST_CUT_RLY_COM] Open Wire Inspection 

NOTICE: 

Before disconnecting the PCM connector, jump the SCS line with the HDS, and wait more than 1 minute.

Test Procedure 

• Preparation
• • Starter cut relay 1: disconnected
  • PCM connector B (72P): disconnected
• Procedure
• • Perform the inspection according to the following table.

			(Disconnected)Starter cut relay 1 4P socketfemale terminals	(Disconnected) PCM connector B (72P) - Refer to: PCM Connector for Inputs and Outputs(3.0L Engine) or PCM Connector for Inputs and Outputs(2.0L Engine) female terminals
		IG Mode	Courtesy of HONDA, U.S.A., INC.	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
	START_DIAG [ST_CUT_RLY_COM] open wire inspection	OFF			There is less than 1 Ohm

Results 

• If abnormal, there is a problem in the circuit.
• If it is normal, there is a problem with the PCM.