DTC P0761

DTC P0761  : Shift Solenoid Valve C Stuck OFF

DTC (A/T)

1. ATF check

   -1. Warm up the engine to normal operating temperature (the radiator fan comes on).

   -2. Make sure that the transmission is filled to the proper level, and check for fluid leaks.

   -3. Drain the ATF through a strainer. Inspect the strainer for metal debris or excessive clutch material.

   Does the strainer have metal debris or excessive clutch material?

   YES 

   Replace the transmission .

   NO 

   Replace the ATF , then go to step 2.

2. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Start the engine.

   -4. Test-drive the vehicle in reverse gear.

   NOTE: Repeat two or three times if shifts are normal.

   Does the vehicle move in reverse?

   YES 

   Intermittent failure, the system is OK at this time.

   NO 

   The failure is duplicated. Go to step 3.

3. Shift solenoid valve C check

   -1. Select Shift Solenoid Valve C in the Miscellaneous Test Menu, and check that shift solenoid valve C operates with the HDS.

   Shift Solenoid Valve C

   Is a clicking sound heard?

   YES 

   Shift solenoid valve C is OK. Faulty reverse inhibitor valve or shift fork shaft. Replace the main valve body (reverse inhibitor valve), the regulator valve body (shift fork shaft), or the transmission . If replacing the main valve body or the regulator valve body, clean off any metal debris or excessive clutch material inside the transmission, the ATF hoses, the ATF pipes, and the hydraulic circuit. Then, replace the main valve body or the regulator valve body and the torque converter.

   NO 

   Replace shift solenoid valve C .