Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Acura >> 2012 >> TL SH-AWD, Automatic Trans >> Repair and Diagnosis >> Electrical >> Gauges >> Gauges >> DTC Troubleshooting >> DTC U0127: Gauge Control Module Lost Communication With the TPMS Control Unit (TPMS Message)

DTC U0127: Gauge Control Module Lost Communication With the TPMS Control Unit (TPMS Message)

NOTE:
  1. Clear the DTCs with the HDS.
  2. Turn the ignition switch to LOCK (0) and then back to ON (II), or press the engine start/stop button to select the OFF mode and then the ON mode.
  3. Wait for at least 6 seconds.
  4. Check for DTCs with the HDS.

    Is DTC U0127 indicated? 

    YES  -Go to step 5.

    NO  -Intermittent failure, the system is OK at this time. Check for loose or poor connections between the gauge control module and the TPMS control unit.

  5. Check for TPMS DTCs with the HDS.

    Are any DTCs indicated? 

    YES  -Go to the TPMS indicated DTCS TROUBLESHOOTING , then recheck.

    NO  -Go to step 6.

  6. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
  7. Disconnect the gauge control module 32P connector.
  8. Disconnect the TPMS control unit 20P connector.
  9. Check for continuity between the gauge control module 32P connector terminals No. 13 and No. 14 and TPMS control unit 20P connector terminals No. 11 and No. 2 respectively.
    Fig 1: Checking Continuity Between Gauge Control Module 32P Connector And TPMS Control Unit 20P Connector
    G08071555Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Substitute a known-good TPMS control unit (see TPMS CONTROL UNIT REPLACEMENT ), and recheck. If the indication goes away, replace the original TPMS control unit. If the DTC is still present, replace the gauge control module (see GAUGE CONTROL MODULE REPLACEMENT ).

    NO  -Repair an open or poor connection in the wire between the TPMS control unit and the gauge control module.