DTC P0685: ECM/PCM Power Control Circuit/Internal Circuit Malfunction
NOTE:
- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION )
- If the problem doesn't return after you clear the DTC, or it this DTC is stored intermittently, check for loose terminals at the IGP line connectors before replacing the ECM/PCM
- Turn the ignition switch to ON (II)
- Clear the DTC with the HDS
- Start the engine, then let it idle for 30 seconds
- Turn the ignition switch to LOCK (0)
- Start the engine, then let it idle for 30 seconds
- Turn the ignition switch to LOCK (0)
- Turn the ignition switch to ON (II)
- Check for Temporary DTCs or DTCs with the HDS
Is DTC P0685 indicated?
YES -Go to step 9
NO -Intermittent failure, the system is OK at this time
- Update the ECM/PCM if it does not have the latest software (see ECM/PCM UPDATE ), or substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM )
- Start the engine, then let it idle for 30 seconds
- Turn the ignition switch to LOCK (0)
- Start the engine, then let it idle for 30 seconds
- Turn the ignition switch to LOCK (0)
- Turn the ignition switch to ON (II)
- Check for Temporary DTCs or DTCs with the HDS
Is DTC P0685 indicated?
YES -If the ECM/PCM was updated, substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ), then go to step 10 If the ECM/PCM was substituted, go to step 1
NO -If the ECM/PCM was updated, troubleshooting is complete If the ECM/PCM was substituted, replace the original ECM/PCM (see ECM/PCM REPLACEMENT ) If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting