Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Acura >> 2009 >> CSX Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Keyless/Power Door Locks/Security System) >> Trunk Lid Release Actuator Test

Trunk Lid Release Actuator Test

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the trunk lid, and remove the trunk lid trim (see TRIM REMOVAL/INSTALLATION - TRUNK LID )
  2. Disconnect the 3P connector (A) from the trunk lid latch switch/trunk release actuator (B)
    Fig 1: Identifying 3P Connector, Trunk Lid Latch Switch And Trunk Release Actuator
    G05988885Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check actuator operation by connecting power to the terminal No 3 and ground to terminal No 2 momentarily to prevent damage to the actuator The actuator should work
  4. If the actuator does not work, replace the trunk lid latch switch/release actuator assembly (see TRUNK LID LATCH REPLACEMENT )
scientia non olet · About Mike's Workshop Manuals