DTC 64-11: Steering Angle Sensor Power Circuit Short
- Turn the ignition switch ON (II).
- Clear the DTC with the HDS.
- Turn the ignition switch OFF, then turn it ON (II) again.
- Check for DTCs with the HDS.
Is DTC 64-11 indicated?
YES -Go to step 5.
NO -Intermittent failure, the system is OK at this time.
- Turn the ignition switch OFF.
- Disconnect the steering angle sensor 5P connector.
- Disconnect the VSA modulator-control unit 37P connector.
- Check for continuity between steering angle sensor 5P connector terminal No. 5 and body ground.Fig 1: Checking Continuity Between Steering Angle Sensor 5P Connector Terminal No. 5 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Repair short to body ground in the wire between the steering angle sensor and the VSA modulator-control unit.
NO -Replace the VSA modulator-control unit (see VSA MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION ).