Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Acura >> 2009 >> CSX Base, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC >> Climate Control >> Mode Control Motor Replacement

Mode Control Motor Replacement

  1. Remove the glove box (see PASSENGER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION ).
  2. Remove the wire harness clip (A), the self-tapping screws, and the passenger's heater duct (B).
    Fig 1: Identifying Wire Harness Clip, Self-Tapping Screws And Passenger's Heater Duct
    G06269172Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the 7P connector (A) from the mode control motor (B). Remove the self-tapping screws and the mode control motor from the heater unit.
    Fig 2: Identifying 7P Connector From Mode Control Motor
    G06269173Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make sure the motor runs smoothly.
scientia non olet · About Mike's Workshop Manuals