Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Acura >> 2007 >> RL >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (TPMS (Tire Pressure Monitoring System)) >> System Description >> TPMS Control Unit Inputs and Outputs for Connector A (14P)

TPMS Control Unit Inputs and Outputs for Connector A (14P)

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying TPMS Control Unit Inputs And Outputs For Connector Terminal (14P)
G05461736Courtesy of AMERICAN HONDA MOTOR CO., INC.
CONNECTOR TERMINAL REFERENCE

Terminal number Wire color Terminal sign (Terminal name) Description Signal
Terminal Conditions Voltage
1 RED/WHT +B (Battery positive) Power source for the TPMS control unit 1-GND At all times Battery voltage
3 BLK GND (Ground) Ground for the TPMS control unit 3-GND At all times Less than 0.1 V
5 YEL IG1 (Ignition 1) Power source for activating the system 5-GND Ignition switch ON (II) Battery voltage
Ignition switch OFF Less than 0.1 V
8 PUR LF LF PWR. (LF low frequency power) Power source for the left-front initiator 8-GND For 5 seconds with ignition switch ON (II) About 7 V
After 5 seconds with ignition switch ON (II) -
9 PNK RF LF PWR. (RF low frequency power) Power source for the right-front initiator 9-GND For 5 seconds with ignition switch ON (II) About 7 V
After 5 seconds with ignition switch ON (II) -
10 GRN/ORN LR LF PWR. (LR low frequency power) Power source for the left-rear initiator 10-GND For 5 seconds with ignition switch ON (II) About 7 V
After 5 seconds with ignition switch ON (II) -
11 BLU RR LF PWR. (RR low frequency power) Power source for the right-rear initiator 11-GND For 5 seconds with ignition switch ON (II) About 7 V
After 5 seconds with ignition switch ON (II) -