Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Acura >> 2005 >> RL >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Wiper System & Washer System) >> Washer Fluid Level Switch Test >> Canada models

Canada models

WARNING: This page is about a different car, the 2008 Acura TL and 2007 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right inner fender (see FRONT INNER FENDER REPLACEMENT ).
  2. Disconnect the 2P connector (A) from the washer fluid level switch (B).
    Fig 1: Identifying Washer Fluid Level Switch And 2P Connector
    G05462781Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the washer fluid level switch from the reservoir.
    NOTE: Fluid may flow out of the opening.
  4. Check for continuity between the No. 1 and No. 2 terminals in each float position (C).
    • There should be continuity when the float is down.
    • There should be no continuity when the float is up.
  5. If the continuity is not as specified, replace the switch.
scientia non olet · About Mike's Workshop Manuals