Pulser Test

5. Reconnect the 6P connector to the window motor.
6. Check for voltage between the terminals.
- There should be battery voltage between the No. 4 [No. 1] (+) and No. 3 (-) terminals when the ignition switch is ON (II).
  [ ] : Front passenger's window motor
- Connect an analog voltmeter between the No. 2 (+) and No. 3 (-) terminals, and run the window motor down or up. The voltmeter needle should move back and forth alternately (a digital voltmeter should show the average voltage between 0-5 V).
- Connect an analog voltmeter between the No. 1 [No. 4] (+) and No. 3 (-) terminals, and run the window motor at down or up. The voltmeter needle should move back and forth alternately.
  [ ] : Front passenger's window motor
7. If the voltage is not as specified, do the window switch input test;
- Master switch terminals: B2, B7, B8 and B10 (see step 7).
- Passenger's switch terminals: No. 2, 7, 8, and 10 (see step 6).
8. If the switch test is OK, replace the power window motor.
9. Reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT ).