Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Acura >> 2004 >> MDX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (TPMS (Tire Pressure Monitoring System)) >> Initiator Replacement >> Front

Initiator Replacement: Front

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to LOCK (0).
  2. Raise the front of the vehicle, and support it with safety stands in the proper locations (see LIFT AND SUPPORT POINTS ).
  3. Remove the front wheel.
  4. Remove the front inner fender (see FRONT INNER FENDER REPLACEMENT ).
  5. Disconnect the initiator connector (A).
    Fig 1: Initiator Connector And Initiator With Torque Specification
    G05486767Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Remove the initiator (B) from the inner side of the wheelwell.
  7. Install the initiator in the reverse order of removal.
scientia non olet · About Mike's Workshop Manuals