Climate Control Power and Ground Circuit Troubleshooting
- Check the No. 14 (10 A) fuse in the under-dash f use/relay box.
Is the fuse OK?
- YES - Go to step 2.
- NO - Replace the fuse, and recheck.
- Disconnect the climate control unit 30P connector.
- Turn the ignition switch ON (II).
- Measure the voltage between the No. 15 terminal of the climate control unit 30P connector and body ground.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there battery voltage?
- YES - Go to step 5.
- NO - Repair open in the wire between the No. 14 fuse in the under-dash fuse/relay box and the climate control unit.
- Turn the ignition switch OFF.
- Check for continuity between the No. 1 terminal of the climate control unit 30P connector and body ground.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
- YES - Check for loose wires or poor connections at the climate control unit 30P connector. If the connections are good, substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control unit.
- NO - Check for an open in the wire between the climate control unit and body ground. If the wire is OK, check for poor ground at G402.