Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Acura >> 1996 >> 3.2TL >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Specifications & Procedures) >> Wheel Alignment Procedures >> Toe-In Adjustment >> Rear (Except Integra)

Rear (Except Integra)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 1998 Acura Integra, 1998 Acura 3.5RL, 1998 Acura 3.2TL, 1998 Acura 3.0CL, and 1998 Acura 2.5TL. However, it is still accessible from the selected car via links, so may be relevant.

Release parking brake. If parking brake is engaged, toe-in measurement may be incorrect. Hold adjuster bolt on lower control arm, and loosen lock nut. See Fig 1. Turn adjuster bolt until toe-in is as specified. See WHEEL ALIGNMENT SPECIFICATIONS . Install new lock nut, and tighten to specification. See TORQUE SPECIFICATIONS .

Fig 1: Adjusting Rear Toe-In (Typical, Except Integra)
G92A00968Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About Mike's Workshop Manuals